Semiconductor Materials: Physical and Electrical Properties with Experimental Structural Characterization of Zinc Oxide (ZnO) Using X-Ray Diffraction (XRD)

Authors

  • Mohammed L. Ali, Alan Ghafour Tawfeeq. Haval Nooradin Kakaamin Author

DOI:

https://doi.org/10.70882/pahyh878

Keywords:

Debye-Scherrer Equation, Semiconductor Materials, Zinc oxide (ZnO), X-ray Diffraction (XRD), Wurtzite Structure, Crystallite Size.

Abstract

Semiconductor materials underpin modern electronic and optoelectronic technologies because their electrical and optical responses can be tailored through composition, structure, and processing. Zinc oxide (ZnO), a widely studied II–VI semiconductor, typically adopts the hexagonal wurtzite crystal structure. This study reviews selected semiconductor fundamentals and reports structural characterization of ZnO powder by X-ray diffraction (XRD). Data were collected with a PANalytical diffractometer using Cu Kα radiation (λ = 0.15406 nm) at 45 kV and 40 mA. The scan covered 2θ = 20°–60° with a step size of 0.015°. Five diffraction reflections were reported at 32.443°, 34.778°, 36.940°, 48.295°, and 57.875°, and indexed to the (100), (002), (101), (102), and (110) planes, respectively. Their positions are consistent with the hexagonal wurtzite phase of ZnO. The crystallite size was reported as 34.4 nm, estimated from the (002) reflection using the Debye–Scherrer method. However, the numerical full width at half maximum (FWHM) and any correction for instrumental broadening were not provided. Consequently, the reported size cannot be independently reproduced or verified from the available information and should be interpreted as an estimate. The presented measurements establish the phase-consistent diffraction features of the powder within the stated angular range; they do not, by themselves, determine optical or electrical performance. The experimental scope is therefore limited to structural characterization. Further work should report peak-width data and the procedure for instrumental-broadening correction to support crystallite-size analysis. Complementary optical and electrical measurements are also needed to assess the material’s functional properties and its potential suitability for device applications.

Downloads

Download data is not yet available.

Downloads

Published

2026-11-19

How to Cite

Semiconductor Materials: Physical and Electrical Properties with Experimental Structural Characterization of Zinc Oxide (ZnO) Using X-Ray Diffraction (XRD). (2026). Journal of Pure and Applied Sciences (Science Forum), 26(5 (Special). https://doi.org/10.70882/pahyh878

Similar Articles

151-160 of 200

You may also start an advanced similarity search for this article.